UNS S32900 seamless pipes and tubes are duplex stainless steel products known as Type 329. The UNS S32900 seamless tube has a chemical composition of 23 to 28% chromium, 2.5 to 5% nickel and 1 to 2% molybdenum. The Type 329 seamless pipe is one of the first duplex grades and it has a structure of ferrite and austenite. The duplex structure gives the S32900 tube a minimum yield strength of 70 ksi and good resistance to chloride stress corrosion cracking. The high chromium gives the 329 stainless steel tube good resistance to pitting and to many acids. UNS S32900 seamless pipes and tubes are used in heat exchangers, chemical plants, pulp and paper plants, pump shafts, etc. USA Piping Solution is a supplier of UNS S32900 seamless pipes and tubes in the USA. We supply these products with mill test certificates.
Why Type 329 Is Still Ordered
Newer duplex grades have replaced Type 329 in most new designs. UNS S32900 is still ordered for three reasons. Existing heat exchangers and equipment were designed in 329, and replacement tubes must match. Some European drawings call for 1.4460. And 329 is used for seamless tube and bar parts that are not welded, where its lower cost is an advantage.
Applications
- Heat exchangers: replacement tubes in existing 329 bundles. Other grades are on the Heat Exchanger Tubes & Pipes page.
- Chemical plants: tubes for nitric acid and other oxidizing acid service.
- Pulp and paper plants: digester and liquor service.
- Machined parts: pump shafts and sleeves from tube and hollow bar.
Testing & Documentation
UNS S32900 seamless pipes and tubes are supplied with a mill test certificate. The certificate shows the heat number, chemical analysis, tensile results and hardness. Each length is hydrostatically tested or tested by a non-destructive electric test. Our Quality Policy page explains how incoming material is checked.
Related Products
UNS S32950 Duplex Seamless Tubes · Duplex 2205 Seamless Tubes · Heat Exchanger Tubes & Pipes
Frequently Asked Questions
1. What is UNS S32900?
UNS S32900 is Type 329 duplex stainless steel, with 23 to 28% chromium, 2.5 to 5% nickel and 1 to 2% molybdenum.
2. Is 329 stainless steel a duplex steel?
Yes. Type 329 has a mixed structure of ferrite and austenite and is one of the first duplex grades.
3. Can 2205 replace Type 329?
2205 is the usual modern choice and welds better. On existing equipment the change must be approved by the responsible engineer.
4. Is UNS S32900 the same as 1.4460?
EN 1.4460 is the European grade that corresponds to Type 329.