SS 310H Seamless Pipes & Tubes

Stainless Steel 310H Seamless Pipes & Tubes Supplier USA | ASTM A312 TP310H

Get a Quick Quote
Standards
ASTM A312 / A213
UNS
S31009
Type
Seamless
Nominal
25Cr-20Ni

Stainless steel 310H seamless pipes and tubes are heat-resistant austenitic steel products for furnace and heater service. The SS 310H seamless pipe has a chemical composition of 24 to 26% chromium and 19 to 22% nickel, and the carbon is controlled between 0.04 and 0.10%. The high chromium gives the 310H seamless tube very good resistance to oxidation and scaling at high temperature. The high nickel keeps the TP310H pipe tough and stable in hot service. The 310H stainless steel pipe has a minimum tensile strength of 75 ksi and a minimum yield strength of 30 ksi. SS 310H seamless pipes and tubes are used in furnaces, radiant tubes, burner parts, heat treatment equipment, steam reformers, recuperators, etc. USA Piping Solution is a supplier of stainless steel 310H seamless pipe and tube in the USA. We supply these products with mill test certificates.

Send Us Your SS 310H Pipe or Tube Requirement →

Oxidation Resistance and Temperature

The scaling resistance of a stainless steel in hot air goes up with the chromium content.

Grade

Chromium

Nickel

Typical maximum temperature in air, continuous service

304H

18 to 20%

8 to 11%

About 1650°F (900°C)

321H / 347H

17 to 19%

9 to 13%

About 1650°F (900°C)

310H

24 to 26%

19 to 22%

About 2000°F (1095°C)

These figures are for scaling in air and not for pressure design. The limit for a pressure part comes from the design code. For hotter or more severe furnace service, the next grades are on the 253 MA Pipes & Tubes and Incoloy 800H Tube pages.

Testing & Documentation

SS 310H seamless pipes and tubes are supplied with a mill test certificate. The certificate shows the heat number, chemical analysis, tensile results and grain size. Each length is hydrostatically tested or tested by a non-destructive electric test. Our Quality Policy page explains how incoming material is checked.

Frequently Asked Questions

1. What is the difference between 310S and 310H stainless steel?

310H has a controlled carbon content of 0.04 to 0.10% for better strength at temperature. 310S has a carbon limit of 0.08% maximum and is easier to weld.

2. What temperature can 310H stainless steel take?

310H resists scaling in air up to about 2000°F (1095°C) in continuous service. The limit for a pressure part comes from the design code.

3. Is 310H good for corrosion service?

310H is made for heat. It has no molybdenum, and its higher carbon can sensitize, so it is not the first choice for wet corrosive service.

4. Is 310H the same as 310HCbN?

No. 310HCbN (UNS S31042) has added niobium and nitrogen and is a different alloy with higher creep strength.

Product Grades



Request a Quote

We respect your privacy.